Jun 15, 2024 Leave a message

How about repair welding?

How about repair welding?
This question cannot be generalized and needs to be analyzed according to your specific situation.

The advantages of repair welding are:
(1) It can repair parts damaged by various reasons, such as wear, breakage, fracture, crack, pit, etc.;
(2) Most of the commonly used metal materials in mechanical parts can be repaired by welding;
(3) The repair quality is high, and some parts are more durable after repair;
(4) The productivity is high and the cost is low;
(5) The general welding equipment is simple, easy to operate, and convenient for field repair.

info-581-415

The disadvantages of repair welding are:
(1) Welding deformation and stress. The local and uneven heating of the workpiece during repair welding is the cause of welding deformation and stress. When the deformation exceeds the allowable value, it needs to be corrected, which is not only time-consuming, but sometimes even scrapped due to ineffective correction. In order to prevent and reduce deformation, some special measures are often needed, such as using the reverse deformation method (that is, before welding, the weldment is deformed in the opposite direction to offset the deformation caused by welding) to control deformation, and using the assembly and welding sequence to control deformation.
(2) Welding cracks. Cracks are one of the more dangerous welding defects. Cast iron and hardened steel parts are prone to cracks during repair welding, which is one of the key issues that need to be paid attention to during welding repair work.
(3) Porosity. Porosity is a hole in the weld caused by the gas in the welding molten pool not having time to escape and remaining in the weld, which affects the strength and sealing of the weld. The shape, size, and number of pores are related to the steel type of the parent material, the properties of the welding rod, and the repair welding technology. The parts sent for repair contain oil, rust and other dirt. If they are not completely removed before welding, it is easy to cause pores.
(4) The strength of the repaired joint. For general steel parts, this problem is not big. However, for materials that have been heat-treated and strengthened, the parent materials on both sides of the weld will undergo changes in structure and corresponding properties after being affected by heat during repair welding, and the strength requirements of the joint and the parent material are not easy to meet. For small-sized parts, the overall heat treatment after repair welding can be used to solve the problem. It is impossible to perform overall heat treatment on large-sized components. At this time, a series of measures need to be taken in terms of welding methods, welding materials and processes.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry