May 14, 2025 Leave a message

How to adjust the opening gap of the wire cutter

 

Adjust the opening degree of the jaws by rotating the adjustment screw and ensure that the cutting blades are aligned
The opening gap adjustment of the wire cutter is mainly achieved through the following steps, which need to be combined with the operating precautions to ensure safety and effectiveness:

I. Adjustment method
‌Adjust the opening degree of the jaws‌

Tighten the adjustment screw near the handle (usually the screw on the connecting arm) clockwise to reduce the opening gap, and loosen it counterclockwise to increase the gap.

Adjust according to the thickness of the cable: thicker cables require a larger opening degree to clamp firmly, and thinner cables require a smaller gap to avoid sliding.
‌Align the cutting edge‌

Check the alignment of the upper and lower blades when they are closed. If there is misalignment, fine-tune the screws or splints that fix the blades to ensure that the two blades are completely overlapped.
If the blade is loose (such as the splint screw is not fixed), it may swing or misalign during cutting and needs to be re-tightened.
II. Precautions
‌Maintenance preparation‌

Clean the dirt on the pliers body before adjustment, and lubricate the moving parts (such as hinges and screws) to ensure smooth adjustment.
Check the blade status: If the blade is blunt or broken, it needs to be polished and repaired first, otherwise it will affect the cutting effect.
‌Operation details‌

When adjusting the screw, the force should be moderate. Over-tightening may damage the thread or cause deformation of the parts.
After adjustment, test: cut the same type of cables to observe whether it is clean and neat, and whether the clamping is stable.
‌Safety protection‌

It is recommended to wear gloves during operation to prevent scratches on the blade or splashing of metal debris.
For live work, insulated handle wire cutters (working voltage below 1000V) must be used to avoid electric shock.
3. Adjustment suggestions for different scenarios
‌Automotive maintenance‌: When frequently cutting cables of different thicknesses, it is necessary to dynamically adjust the opening and closing degree, and give priority to models with a large blade gap adjustment range.
‌Electrician operation‌: If used for live lines below 380V, it is necessary to ensure that the insulation performance is intact and there are no burrs after cutting to prevent short circuits.
Through the above steps, the gap of the wire cutters can be adjusted efficiently and the tool life can be extended. If you need an intuitive demonstration, you can refer to the video tutorial (such as the relationship between the rotation direction of the adjustment screw and the gap change).

Send Inquiry

whatsapp

Phone

E-mail

Inquiry